Need engine help

SnohoBassGuy · Post by **SnohoBassGuy** » Sun Jan 25, 2009 11:06 am

I was wondering if anyone out there would like to make some money and take a look at my 4hp Johnson motor. Its real clean, but for some reason, it wont ramp up all the way. Literally, I can go faster with a trolling motor.

You can call me at 425.345.1507 for the details if you're interested. Any help would be great. I got banks lake in may, and would love to have this resolved by then. I'm up in everett, but could deliver the engine if need be.

Post by **Bodofish** » Sun Jan 25, 2009 12:12 pm

By ramp up, if you mean go to full rpm then the first things to look at are the throttle, will it open the carb all the way. Are there any filters plugged, many have pumper carbs with internal filters/screens and next would spark advance dependeing on the age. Just straight up small engine trouble shooting. Let us know what you find.

JohnKTKim · Post by **JohnKTKim** » Sun Jan 25, 2009 8:43 pm

hey it happened to my johnson turned out te be a faulty throttle cable (was spendy to have it repaired)

SnohoBassGuy · Post by **SnohoBassGuy** » Mon Jan 26, 2009 12:16 pm

You know, I have looked it over and cant seem to find anything wrong. But I never took anything apart on it yet, just visual inspection.

What did the throttle cable cost you? Could I get one used and will it work good?

JohnKTKim · Post by **JohnKTKim** » Tue Jan 27, 2009 6:24 pm

that cable together with install cost me 150 bucks - turned around and sold the motor 400

from what the repair place told me was that it was difficult, probably to justify an hour’s labor (100/hr)

if you could get the cable used it should work, the faulty cable had some plastic thingi broke at the motor end… hope this helps

Post by **Bodofish** » Tue Jan 27, 2009 7:20 pm

If it's a 2 stroke johnson stop wasting your time and and pull the pumper carb. $ to donughts the screens in the pumper carb are clogged. Very common if the motor was not run dry after the last use.

SnohoBassGuy · Post by **SnohoBassGuy** » Fri Jan 30, 2009 10:15 am

You know of any links to sites where they might demonstrate this or show that part on a diagram. I do some mechanic work, but never on outboards.

SnohoBassGuy · Post by **SnohoBassGuy** » Tue Feb 10, 2009 11:55 am

Anyone willing to take a look at this engine? I can bring it by pretty much any where around Everett/Seattle.

SnohoBassGuy · Post by **SnohoBassGuy** » Wed Feb 18, 2009 12:19 pm

bump....Still looking for help.

Northwest Fishing Reports

Need engine help

Need engine help

RE:Need engine help

RE:Need engine help

RE:Need engine help

RE:Need engine help

RE:Need engine help

RE:Need engine help

RE:Need engine help

RE:Need engine help